How to install water heater at home.





This page shows you how I install a hot shower at my condominium. However, you need to have basic knowledge about electronics and you will be fine.


First step:
You need to cut off the circuit breaker before doing this works.

Second step:

Find the right wire color and meaning of the color. As you can see in the above picture, the ground wire always green in color, and the hot wire is black. Unlike DC current load AC current use black color as a hot wire but DC current use black as a ground.

Third step:

Check resistance between neutral and ground, it should be 0 ohms or no more than 1 ohms. The resistance above 1 ohm means that the ground wire has a problem and elb, elcb may not work.

Last step:

Connect three wires to a hot shower and everything will be finished.

See the video below for the complete project.

Comments

Popular posts from this blog

How to connect volume control to an amplifier

How to add power supply filter capacitor to amplifier board.

5 watts amplifier TDA7056A wiring diagram

10 watts 8 ohms class d amplifier pam8610 sound test

Hall effect sensor wiring diagram and test video

how to make condenser microphone pre-amplifier

simple bass booster circuit diagram

PAM 8403 board amp wiring diagram

Resistor color code

How to make a simple audio pre-amplifier